Designed for applications where 3-axis travel is not required and existing spray booths lack structural integrity.

• Controls - Direct acting hydraulics for positive and precise control.

• Steering - Steering is caster type which affords this machine unsurpassed maneuverability. (LPSV-1932 has 6” inside turning radius, LPSV-2646 has 44” inside turning radius).

• Extension Deck - a 3’ rollout extension deck. Guardrails are of heavy duty rectangular tubing with a release handle on the guardrail. Rollout capacity 250 lbs.

• Platform - all steel deck has a slip resistant surface and 6” toe boards. Lanyard attachment points front and rear. Heavy duty rectangular tubing is used for the guardrails.

• Scissor Arms - The scissor arms are constructed of heavy duty tubular steel with cross bracing tubes at the ends for through shafts. All pivot points fitted with self-lube bushings. Lift cylinder is equipped with a holding valve.

• Swing out side covers on the base for access to all components.

All Models Include

• Pothole Protection - Ground clearance between wheels is reduced to ½” to prevent tipping if a wheel should happen to drop into a hole.

• 20 F.P.M. lift speed, 25 F.P.M. lowering speed

• Power source - Compressed air (unit requires clean dry air supply of 80 SCFM at 100 PSI). Note: Actual air consumption dependent on lift duty cycle.

Standard & Lateral Drive Modes

Improves productivity by providing quick, precise and safe access to large equipment, confined spaces and work areas. Lateral 4 wheel drive allows operator to maneuver into places that standard scissor lifts can’t reach.

• Standard drive mode uses front wheels to drive and steer for minimum turning radius.

• Lateral drive mode, selected at the flip of a switch, turns all 4-wheels 90 degrees enabling entire unit to travel sideways.

• Power source is 24 volts DC with (8) six volt batteries and automatic 50A charger.

• Operator platform of welded steel construction with 42” guardrails and lanyard tie off points in safety plate floor for operator safety.

• 60 F.P.M. travel speed (fully lowered), 30 F.P.M. travel speed (any raised position in standard drive). 15 F.P.M. travel speed in lateral drive mode.

• 18 F.P.M. lift/lower speed.

These units are also availabhle in non-electric fully pneumatic/hydraulic powered versions for use in hazardous environments (compressed air source not included).

All Models Include

• Upper control station with E-stop and battery condition indicator.

• Lower control station to raise and lower platform from ground for safety and maintenance.

• 24” wide access gate.

• 14” OD x 5” wide solid rubber tires.

• Holding valves on lift cylinders to prevent uncontrolled descent of operator platform in event of hydraulic hose rupture or loss of pressure.

• Hour meter.

• PLC control system for reliability and ease of troubleshooting.